Toro 38547 Operator's Manual page 13

1
3
Figure 13
1. Auger/impeller drive
control lever
2. Traction control lever
Traction Control Lever (Fig. 13)—To engage the
traction (wheel drive), press the lever against the left
handgrip. To stop the traction, release the lever.
Speed Shift Control (Fig. 13)—This control has a
neutral position, four forward speeds, and two reverse
speeds. It also controls the power shifting of the
wheels. To select a speed, move the shift control to the
desired position.
Note: Before shifting the gears into or out of reverse, or
when using the Power Shift feature, release the traction
drive control. You man shift between any of the forward
speeds without releasing the traction control lever.
Discharge Chute Control (Fig. 13)—Rotate the
discharge chute control clockwise to move the
discharge chute to the right; counterclockwise to move
the chute to the left.
Auger/Impeller Lockup—When you press both the
auger/impeller drive control lever and traction control
lever, the traction control lever locks the auger/impeller
drive control lever down. Release the traction control
lever to release both levers.
Ignition Switch (Fig. 14)—Insert the key before
starting the engine. To stop the engine, remove the key.
1
Figure 14
1. Ignition switch
2. Choke
4
2
m-4059
3. Speed shift control
4. Discharge chute control
4
3
2
m-4034
3. Throttle
4. Primer
Choke (Fig. 14)—Rotate the choke to the On position
to start a cold engine. As engine warms up, gradually
rotate the choke counterclockwise to the Off position.
Throttle (Fig. 14)—Move the throttle upward to
increase the engine speed; move it downward to
decrease the engine speed. Move the throttle to the Stop
position to stop the engine.
Primer (Fig. 14)—Press the primer to pump a small
amount of gasoline into the engine for improved
cold-weather starting.
Fuel Shutoff Valve (Fig. 15)—Close the valve by
rotating it clockwise. Open the valve by rotating it
counterclockwise. Close the valve when you do not use
the snowthrower.
1
2
1. Fuel shutoff valve
2. Hose clamp
Chute Deflector Handle (Fig. 16)—Move the deflector
handle forward to move the snow stream down and
rearward to move the snow stream up.
1. Deflector handle
Recoil Starter (Fig. 17)—The recoil starter is on the
back side of the engine. Pull the recoil starter to start the
engine.
1. Recoil starter
13
2236
3
Figure 15
3. Fuel line
1
2
176
Figure 16
2. Discharge chute
1
934
Figure 17