Toro 03678 Operator's Manual page 14

Figure 5
1. Opposite carrier-frame tab
D. Mount the rod bracket to the cutting unit tabs
with the carriage bolts and nuts
Important: On cutting unit 4 (left front) and
cutting unit 5 (right front), use the rod-bracket
mounting nuts to install the hose guides to
the front of the cutting-unit tabs
and Figure 7). Position the hose guides so
that they lean toward the center cutting unit
(Figure 7 and
Figure 6
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1
1. Hose guides (each must lean toward the center cutting unit)
6. Lower all the lift arms completely.
2. Rod bracket
(Figure 5).
(Figure 6
Figure 8).
5. Cutting unit 5
6. Reel motor
7. Weight
1. Hose guide (cutting unit 4
shown)
2. Rod bracket
Note: When installing or removing the
cutting units, ensure that the hairpin cotter is
in the spring-rod hole next to the rod bracket.
Otherwise, install the hairpin cotter in the hole in
the end of the rod.
Figure 8
7. Remove the snapper pin and the cap from the
lift-arm-pivot yoke
14
Figure 7
3. Nuts
1
g019284
(Figure 9).