Toro 78395 Operator's Manual page 6

1
Figure 6
1. Clevis pin
4. Attach the pulley box if it is not already on the tractor
(Fig. 7).
1
3
7
2
Figure 7
1. Attach-A-Matic latches
2. Pulley box
3. Idler pulley
4. Belt tension release arm
A. Ensure that the latches on the tractor's front
Attach-A-Matic are open.
B. Slide the pulley box into the Attach-A-Matic
latches and seat it.
C. Close the latches.
2
m–3433
2. Hairpin cotter
6
5
4
m–5510
5. Belt tension adjustment
knob
6. Belt tension indicators
7. Attach-A-Matic buttons
(one on each side)
Attaching the Mower
1. From the right side of the tractor, slide the mower under
the tractor (Fig. 8).
Note: Once the mower is almost under the tractor, you may
need to turn the steering wheel to the left to provide enough
room for the mower to slide completely under the tractor.
Figure 8
1. Front tractor wheels
2. Position the mower so that the slots in the side of each
of the mower mounting brackets (Fig. 9) are aligned
directly below the tractor attachment lift arm.
2
1
Figure 9
1. Slots in the side mounting
brackets (2)
3. Start the tractor.
4. Lower the attachment lift arm fully and adjust the
mower position until you can pull out on the J-pin of
the lift arm and slide it into the slot in the mounting
bracket of the mower (Fig. 10).
6
1
m–3575
m–3574
2. Front to rear adjustment
rod