Toro 78395 Operator's Manual page 10

Front
4
Figure 18
1. Blade oriented front to
rear
2. Measure front blade tip
3. Measure the distance from the front tip of the blade
(Fig. 18) to the flat surface.
4. Carefully rotate the blade tip until it is in the rear
position and measure it in that position.
When the blade tip is in the front position, it should be
1/8 in. (3 mm) lower than when it is in the rear position.
5. If an adjustment is required, turn the adjusting nut
(Fig. 19) on the back of the mower.
To raise the front of the mower, turn the adjustment
nut clockwise.
To lower the front of the mower, turn the nut
counterclockwise.
m–3523
2
3
1
4
3. Rotate front tip to rear
and measure
4. Measure here (side to
side)
10
1
Figure 19
1. Front to rear adjustment rod
Adjusting the Side to Side Blade Cut
This optional adjustment is available if necessary to
compensate for uneven side to side cut.
Equalize the side to side cut by adjusting the two carriage
bolts (Fig. 20) on the mower wheels. Check the height of
the blade at outside blade tips (Fig. 18).
1
Figure 20
1. Side to side adjustment bolts
m–3574
m–3577