Assembly; Loose Parts; Installing The Handles - Toro 38086 Operator's Manual

Assembly

Note: Determine left and right sides of snowthrower by standing in the normal operating position.

Loose Parts

Part
Handles
Capscrews
Curved washers
Speed selector rod
Cotter pin
Flat Washer
Flange locknut
Compression spring
Lower link
Flange locknut
Flange nuts
Discharge chute
Plastic chute retainers
Chute retainer plates
Screws
Locknuts
Worm gear
Bracket
Carriage screw
Flat washer
Locknut
Skids
Flange head screw 3/4 in. (1.9 cm)
Flat washers and locknuts
Key
Specifications and design are subject to change without notice.

Installing the Handles

1. Cut the tie straps that secure the control rods to the
handle.
2. Remove the axle pins from both wheels (Fig. 2) and
slide the wheels outward on the axle approximately
one inch (2.5 cm).
Qty
2
4 Installing the handles
4
1
1 Installing the speed selector rod
1
1 Installing the traction rod
1
1
Installing the auger/impellor drive control
1
linkage
1
1
3
3 Installing the discharge chute
3
3
1
1
Installing the chute control gear
1
1
1
2
2 Installing the skids
2
1 Starting and stopping the engine
7
Use