Greasing The Bearings And Bushings - Toro 30162 Operator's Manual

Greasing the Bearings and
Bushings
The cutting unit must be lubricated regularly. Refer to
the Service Interval Chart on page 12. Grease with
No. 2 general purpose lithium base or molybdenum
base grease.
1. Stop the engine, remove the key and disconnect
the spark plug wire(s) from the spark plug(s).
2. Grease the fittings on the carrier frame mounting
tubes and castor wheels (Fig. 25).
3. Apply a few drops of oil to flotaion cable pulley
bushings (Fig. 26).
4. Grease the three spindle bearings on the deck
(Fig. 27).
Figure 25
1. Carrier Frame Mounting
Tube (Grease Fitting)
1
2
2. Castor Wheel (Grease
Fitting)
Figure 26
1. Pulley (Oil)
1
Figure 27
1. Spindles (Grease)
Maintenance
1
17