Table Of Contents; Introduction - Toro 03681 Operator's Manual

Introduction

Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts,
or additional information, contact an Authorized
Service Dealer or Toro Customer Service and have
the model and serial numbers of your product ready.
Figure 1 identifies the location of the model and serial
numbers on the product. Write the numbers in the
space provided.
1. Location of the model and serial numbers
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
(Figure 2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
© 2007-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
1. Safety alert symbol
This manual uses 2 other words to highlight
information. Important calls attention to special
mechanical information and Note emphasizes general
information worthy of special attention.
Contents
Introduction.................................................................2
Safety ..........................................................................3
Safety and Instructional Decals ...........................3
Setup ...........................................................................4
1 Inspection .........................................................4
2 Cutting Unit Kickstand.....................................4
3 Adjusting the Rear Shield .................................5
4 Mount the Counter Weights ..............................5
Product Overview .......................................................7
Specifications ......................................................7
Cutting Unit Accessories and Kits (see parts
catalog for part numbers).................................8
Operation.....................................................................9
Adjustments ........................................................9
Height of Cut Chart Terms.................................10
Height of Cut Chart ...........................................12
Maintenance..............................................................15
Lubrication........................................................15
Adjusting the Reel Bearings ..............................15
Servicing the Bedbar .........................................16
2
Figure 2
Contact us at www.Toro.com.
Printed in the USA.
All Rights Reserved