Adjusting The Cutting Height; Adjusting The Handle Height - Toro 20793 Operator's Manual

Adjusting the Cutting Height

If the engine has been running, the muffler will be hot and can severely burn you.
Keep away from the hot muffler.
Adjust the cutting height
as desired. Set all four
wheels to the same
height.
Note: To raise the mower,
move all 4 cutting height
levers forward; to lower
the mower, move them all
rearward.

Adjusting the Handle Height

You may raise or lower the handle to a position
comfortable for you.
1. Remove the
lower handle knobs
and lock washers
that attach the
lower handle ends
to the handle
brackets.
m-8097
2. Insert the bolt
through the hole in each
of the handle brackets
that sets the handle to
the desired position.
Note: A is the
highest position; B
(either hole) is the
middle position; and
C is the lowest
position.
9
m-8098
A
B
C
m-8101
3353-459 Rev A
m-5629a
A= 3 cm
E= 8 cm
B= 4 cm
F= 10 cm
C= 6 cm
G=11 cm
D= 7 cm
3. Install the lock
washers and lower
handle knobs and
tighten the knobs as
tight as you can.
Note: Ensure that
each lock washer is
between the handle
bracket and the
lower handle knob.
m-8100
m-8097