Preparing The Mower For Storage; Folding The Handle; Removing The Mower From Storage - Toro 20793 Operator's Manual

Storage
Store the mower in a cool, clean, dry place.
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or bystanders.
Remove the key from the ignition switch before
you service, transport, or store your mower.
Preparing the Mower for
Storage
Gasoline vapors can explode.
S
Do not store gasoline more than 30 days.
S
Do not store the mower in an enclosure near
an open flame.
S
Allow the engine to cool before storing it.
1. On the last refueling of the year, add fuel
stabilizer to the fuel as directed by the engine
manufacturer.
2. Run the mower until the engine stops from
running out of fuel.
3. Prime the engine and start it again.
4. Allow the engine to run until it stops. When you
can no longer start the engine, it is sufficiently dry.
5. Disconnect the wire from the spark plug.
6. Remove the spark plug, add 30 ml of oil through
the spark plug hole, and pull the starter rope slowly
several times to distribute oil throughout the cylinder
to prevent cylinder corrosion during the off-season.
7. Loosely install the spark plug.
8. Tighten all nuts, bolts, and screws.
9. Charge the battery for 24 hours (model 20795
only), then unplug the battery charger and store the
mower in an unheated area. If you must store the
mower in a heated area, you must charge the battery
every 90 days.
19

Folding the Handle

1. Remove the
lower handle knobs
and lock washers.
2. Detach the
handle brackets
(A) from the lower
handle sides.
Note: Attach the lock washers and lower handle
knobs onto the bolts in the handle to prevent
losing them.
3. Rotate the handle forward.
A.
B.
4. To unfold the handle, refer to Unfolding the
Handle on page 6.
Removing the Mower from
Storage
1. Remove the spark plug and pull the recoil start
handle a few times to blow the excess oil from the
cylinder.
2. Install the spark plug and tighten it with a torque
wrench to 20 N
m.
3. Charge the battery (model 20795 only).
4. Connect the wire to the spark plug.
3353-459 Rev A
A
m-8097
m-8110
m-8109