Toro 74568TE Operator's Manual page 58

4. Tighten both the front and rear nuts.
5. Check the front-to-rear pitch of the cutting unit.
6. If the dimensions are not correct, adjust the front and
rear nuts on either side to get the correct front-to-rear
pitch (Figure 87).
1. Adjustment rods
2. Rear nuts
Matching the Height-of-Cut
1. Check the rear tire pressure.
2. Set the height-of-cut to the 7.6 cm (3 inches) position;
refer to Adjusting the Height-of-Cut (page
3. With the machine on level surface, position one blade
front-to-rear.
4. Measure at A, and from a level surface to the cutting
edge of the blade tips
Note: The measurement should be 7.6 cm (3 inches).
Figure 87
3. Front nuts
26).
(Figure 88).
1. Measure from a level
surface
5. If it does not measure correctly, locate the height-of-cut
rod on the right side of the machine
6. Adjust the adjustment bolt until the blade tips match
7.6 cm (3 inches) as shown in
1
2
1. Height-of-cut rod
58
Figure 88
2. Measure the blade at point
A
(Figure
Figure 89.
Figure 89
2. Adjustment bolt
89).
g015336