Toro 74568TE Operator's Manual page 50

Grandstand mower with 122 cm turbo force cutting unit
Hide thumbs Also See for 74568TE:
Table of Contents

Advertisement

Figure 70
1. Cam
8. Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the cam.
Note: Moving the cam clockwise (in the vertical
position) lowers the handle, while moving it
counterclockwise (in the vertical position) raises the
handle.
Important: Ensure that the flat portion of the
cam does not go above a vertical position (right or
left), or you may cause damage to the switch.
2. Nut
Adjusting the Neutral Position for the
Motion-Control Levers
Important: Ensure the tracking of the mower is correct
after adjusting the motion-control levers. Adjusting the
tracking and aligning the motion-control levers front to
back is the same procedure
Note: Adjust the horizontal alignment before the front to
back alignment.
If the motion-control levers do not align front to back, or
the right side control lever does not move easily into the
neutral-lock position, adjustment is required.
1. After the horizontal alignment is finished, check the
front to back alignment by slightly pushing the control
levers forward to take up any slack in the linkage for
the control levers
1
1. Left motion-control lever
2. Right motion-control lever
2. Ensure the right motion-control lever moves easily into
the neutral-lock position.
Note: Turn the cable adjustment clockwise to
move the motion-control handle forward. Turn
the cable adjustment counterclockwise to move the
motion-control handle rearward.
3. Rotate the cable adjustment on right side when
adjustment is needed.
Note: Adjust the cable adjustment in quarter-turn
increments.
4. After the right motion-control lever moves easily into
the neutral-lock position, adjust the left motion-control
lever to align with the right motion-control lever.
5. Check for proper tracking; refer to
Tracking (page
41).
6. Install the cable lock onto the cable-adjusting nuts to
secure the adjustment
50
(Figure
71).
(Figure
71).
2
G012706
Figure 71
3. Neutral-locked position
4. Align the control levers
front to back
Adjusting the
(Figure
72).
3
4

Advertisement

Table of Contents
loading

Table of Contents