Correcting The Mower Quality-Of-Cut - Toro 74568TE Operator's Manual

Note: If the blade stays in a horizontal position, the
blade is balanced and can be used.
1. Blade
3. If the blade is not balanced, file some metal off the end
of the sail area only
4. Repeat this procedure until the blade is balanced.
Installing the Blades
1. Install the blade onto the spindle shaft
Important: The curved part of the blade must be
pointing upward toward the inside of the mower to
ensure proper cutting.
2. Install the spring disk and blade bolt
Note: The spring-disk cone must be installed toward
the bolt head (Figure
3. Torque the blade bolt to 115 to 150 N-m (85 to
110 ft-lb).
1. Sail area of the blade
2. Blade
Figure 81
2. Balancer
(Figure 79).
(Figure
(Figure
82).
Figure 82
3. Spring disk
4. Blade bolt
Correcting the Mower
Quality-of-Cut
If one deck blade cuts lower than the other, correct it as
follows:
Note: Tire air pressure is critical in these procedures; make
sure the rear tires have the correct pressure.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Disconnect the spark plug wire(s) from the spark
plug(s).
4. Adjust the tire pressure in the rear tires to 83 to 97 kPa
(12 to 14 psi).
5. Check that the blades and spindle shafts are not bent;
82).
refer to
6. Set the height-of-cut to the 7.6 cm (3 inches) position;
refer to
82).
Checking the Mower Deck Side-to-Side
Height
1. Adjust the rear-tire pressure.
2. Ensure that the blades are not bent; refer to
for Bent Blades (page
3. Position the blades side-to-side.
4. Measure at the B and C locations from a level surface
to the cutting edge of blade tips
1. Measure from a level
surface
5. The difference between measurements B and C should
be no more than 6 mm (1/4 inch).
Note: If it is not correct, refer to
Deck Side-to-Side Height (page
56
Checking for Bent Blades (page
Adjusting the Height-of-Cut (page
55).
(Figure
Figure 83
2. Measure the blade at
points B and C
57).
55).
26).
Checking
83).
Changing the Mower