Servicing The Engine Oil - Toro 30150 Operator's Manual

Mid–size mower proline gear 13hp with 32in or 36in side discharge mower
Table of Contents

Advertisement

Removing the Foam and Paper Elements
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean around the air cleaner to prevent dirt from getting
into the engine and causing damage (Fig. 32).
4. Unscrew the cover knob and remove the air cleaner
cover (Fig. 32).
5. Unscrew the 2 wing nuts and remove the air cleaner
assembly (Fig. 32).
6. Carefully pull the foam element off the paper element
(Fig. 32).
2
3
4
5
1
Figure 32
1. Engine
2. Cover
3. Wing nut
Cleaning the Foam Element
1. Wash the foam element in liquid soap and warm water.
When the element is clean, rinse it thoroughly.
2. Dry the element by squeezing it in a clean cloth.
Important
Replace the foam element if it is torn or
worn.
6
m–7452
4. Foam element
5. Paper element
6. Cover knob
28
Cleaning the Paper Element
Important
Never clean the paper element with
pressurized air or liquids, such as solvent, gas, or kerosene.
1. Lightly tap the element on a flat surface to remove dust
and dirt (Fig. 32).
2. Inspect the element for tears, an oily film, or damage to
the rubber seal.
3. Replace the paper element if it is damaged, or cannot be
cleaned thoroughly.
Installing the Foam and Paper Elements
Important
To prevent engine damage, always operate
the engine with the complete foam and paper air cleaner
assembly installed.
1. Carefully slide the foam element onto the paper air
cleaner element (Fig. 32).
2. Place the air cleaner assembly onto the air cleaner base
and secure it with the 2 wing nuts (Fig. 32).
3. Place the air cleaner cover into position and tighten the
cover knob (Fig. 32).

Servicing the Engine Oil

Service Interval/Specification
Change the engine oil:
After the first 8 operating hours
After every 100 operating hours
Note: Change the oil more frequently when the operating
conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SF, SG, SH, or SJ)
Crankcase Capacity: 58 ounces (1.7 liter) with the filter
removed; 51 ounces (1.5 liter) without the filter removed
Viscosity: Refer to the table below
USE THESE SAE VISCOSITY OILS

Advertisement

Table of Contents
loading

This manual is also suitable for:

30161

Table of Contents