Wiring Diagram; Cleaning And Storage - Toro 30150 Operator's Manual

Wiring Diagram

J4
J5
WIRE LIST
DESIG. AWG COLOR ROUTE
W1 16 WHITE J2 J4
W2 16 WHITE J2 J3
W3 16 BLUE P1–1 J5
W4 16 BLACK P1–2 J1

Cleaning and Storage

1. Disengage the blade control (PTO) lever and set the
parking brakes.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine cylinder head fins and the blower housing.
Important Wash the machine with a mild detergent and
water. Do not use a pressure washer to wash the machine.
Avoid excessive use of water, especially near the control
panel and engine.
3. Check the brakes; refer to Servicing the Brakes,
page 32.
4. Service the air cleaner; refer to Servicing the Air
Cleaner, page 27.
5. Grease the machine; refer to Greasing and Lubrication,
page 31.
6. Change the crankcase oil; refer to Servicing the Engine
Oil, page 28.
7. Check the tire pressure; refer to Checking the Tire
Pressure, page 31.
8. For long-term storage (more than 90 days) add a
stabilizer/conditioner additive to the fuel in the tank.
W1
W3
1
2
P1 PTO
9. Empty the fuel tank using the following steps:
10. Remove and inspect the spark plug; refer to Servicing
11. With the spark plug removed from the engine, pour two
12. Install the spark plug. Do not connect the wire to the
13. Check and tighten all bolts, nuts, and screws. Repair or
14. Paint all scratched or bare metal surfaces with paint
15. Store the machine in a clean, dry garage or storage area,
38
J3
KILL
W2
W4
A. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
B. Stop engine and wait for all moving parts to stop
before leaving the operating position.
C. Allow the engine to cool and drain the fuel tank;
refer to Servicing the Fuel Tank, page 33, or operate
engine until it stops.
D. Start the engine and run it until it stops. Repeat this
step with the Choke on until engine will not start.
E. Dispose of fuel properly. Recycle per local codes.
Note: Do not store stabilizer/conditioned gasoline over
90 days.
the Spark Plug, page 30.
tablespoons of engine oil into the spark plug hole, then
use the starter to crank the engine and distribute the oil
inside the cylinder.
spark plug.
replace any part that is worn or damaged.
available from an Authorized Service Dealer.
and cover it to protect it and keep it clean.
J2
MAG
J1
GND