Marmitek EASYTOUCH ET35 Owner's Manual page 22

easytouch35_manual ok
5. Display will show the Mode Setup Screen. Press and
release Marmitek X-10 Home Automation key
6. Display will show the Code Setup Screen. Enter 821.
7. Press and release the Touchscreen "EXIT" key to return to
normal operation.
To program the
follow
6. Display will show the Code Setup Screen. Enter 820.
7. Press and release the Touchscreen "EXIT" key to return to
normal operation.
22
6/17/03 10:30 AM Page 22
key to send radio signals, proceed as
1. Activate your ET35 remote by
touching the screen
2. Press and hold the Setup key
until the LED remains on
(occurring after approximately
2-3 seconds) and display shows the Main Setup Screen.
3. Release Setup key.
4. Press and release the Touchscreen "CODE" Key.
5. Display will show the Mode
Setup Screen. Press and release
Marmitek X-10 Home
Automation key
.
.
MARMITEK