Advertisement
Put the plug in the wall socket.
Select the maximum ironing temperature.
Unplug the iron when the temperature power light has gone out.
Hold the iron over the sink, press and hold the self clean button and gently shake the iron to and fro.
Release the self clean button after 5-10 seconds.
Repeat the self clean process if the iron still contains a lot of impurities.
NOTE
Steam and boiling water will come out of the sole-plate, impurities and flakes(if any)will be flushed out.
aTTENTiON: Keep hands and body away from hot water.
Do not push and hold the self clean button while ironing.
Chapter 3: Maintenance and Cleaning
To prevent any risk of burns, all maintenance and cleaning operations should only be
carried out when the unplugged appliance has cooled down for at least 2 hours.
Before cleaning, set the steam control to the "
completely cool down, and then clean with a damp cloth, do not immerse the unit into water or other liquids.
Clean and empty the water tank after every use.
If ironing clothes with high temperature, which is not recommended on the garment table, this will cause burns
to your clothes and residue left on the sole-plate of the unit, it is recommended that you iron over an old cloth to
remove any residue from the sole-plate.
After use, set the steam control to the "
water tank and then store the iron after it has been completely cooled down.
Never use scouring pads, abrasive or chemical cleaners, or solvents
Chapter 4: Storage
Empty the water tank.
Roll up the power cord with cable ties.
Put the iron in the upright position on it's back cover.
Wait at least 30 minutes allowing the sole plate to cool down.
Then you can take away your appliance in order to store it safely and easily.
Important Information
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local Hoover dealer or direct
from Hoover. When ordering spare parts, always check your model number.
Hoover Service
Should you require service at any time, please contact your local Hoover Service Office. Please see all the
contact details below.
7 - GB
", unplug the iron from wall socket, and allow the appliance to
", disconnect the unit from mains socket, empty remaining water from
Advertisement
