Toshiba MMU-AP0074YH-E(-TR) Service Manual page 122

N . o P a t r n a m e
3 E-cover 1. Detachment
2. Attachment
Be sure not to catch TA sensor in the E-cover; otherwise the
equipment cannot operate correctly.
If there is clearance, dust may enter in the electrical control box.
4 E-box 1. Detachment
2. Attachment
Be sure to fix surely as before the lead wires of which clamps and
tie wrap were taken off.
Check that lead wires of the drain pump do not reach the fan so
that they are not caught in the fan, and then fix them.
(In case of drain pump incorporated model)
P o r
1) Perform work 1. of 2.
2) Take off screws fixing E-cover, and then remove hooks of
the hooking part by lifting up. (Ø4 × 10, 2 pcs)
1) Hang on E-cover to hooks of the hooking part so that it does
not fall down.
NOTE
2) Using the screws taken off in procedure 1. 2) of 3, attach E-
cover while holding it with hands without clearance.
NOTE
1) Perform works 1. of 2 and 1. of 3.
2) Remove clamps and tie wrap at upper part of the photo.
(Drain pump incorporated model: 3 positions)
(Natural drain model: 2 positions)
3) Take off screws fixing E-box. (Ø4 × 10, 2 pcs)
E-box does not fall down under condition that screws are
taken off.
4) Remove the E-box over sheeting metal which was fixed
with screws.
1) Insert hooks of E-box into the hooking part of the main
body.
2) Store E-box as before, and then attach it by using screws
taken off in procedure 1. 3) of 4.
NOTE
NOTE
c e d u e r
– 122 –
R e m a k r s
2 screws
TA sensor
E-cover
Clamp
Tie wrap
Drain pump 2 screws
Lead wire:
For only drain pump incorporated model
E-cover
Hooking part
Clamp