Reboot; Specifications - Bowers & Wilkins P7 Wireless User Manual

10. Reboot

To perform a reboot use a straightened paper-clip to
press and hold the Reboot button for two seconds
as illustrated in Diagram 6. The headphones will turn
off, press Power on and reboot will be complete.
Note: Performing a reboot will not clear the
paired device memory.
11. Cleaning your P7 Wireless
Clean your P7 Wireless by using a damp cloth and
dabbing the leather until clean, do not rub the cloth
on the leather. Do not use cleaning detergents or
leather polish, doing so may cause damage to the
product.

Specifications

Model
Description
Technical features
Drive units
Frequency range
Impedance
Distortion (THD)
Sensitivity
Inputs
Cable length
Bluetooth codecs
Net weight
Diagram 6
Reboot
P7 Wireless
Wireless Headphones
Nylon damped cone
CCAW coil
Dual cavity ear cushions
Changeable ear cushions
Bluetooth v4.1
Folding (hinged) design
2x ø40mm (1.6in) full range
10Hz – 20kHz
22 ohms (passive)
<0.3% (1KHz/10mW)
111dB/V at 1kHz
3.5mm stereo jack (TRS 3-pole unbalanced stereo spec.)
Micro USB 2.0 (Battery Charging, Service & FW update)
2x microphones supporting CVC2 algorithm
1.2m
aptX (standard latency)
AAC
SBC
325g
6