To Set The Clock - Monogram ZEK756GP Use And Care Manual

Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a Timed
Bake or CLEAN cycle.
Timer
The timer is a minute timer; it does
not control oven operations. The
maximum setting on the timer is
9 hours and 55 minutes.
To Reset the Timer
If "TIMER" is showing, press the INCREASE
or DECREASE pad until desired time is reached.
If "TIMER" is not showing, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tones
The End of Cycle tone is a series of three beeps
followed by one beep every six seconds. If you would
like to remove the signal that beeps every six seconds,
press and hold the CLEAWOFF pad for 10 seconds.
To return the signal that beeps every six seconds,
press and hold the CLEAWOFF pad for 10 seconds.
Power Outige
After a power outage, when power is restored,
the display will flash and time shown will no longer
be correct-for example, after a 5-minute power
interruption the clock will be 5 minutes slow.
All other functions that were in operation when the
power went out will have to be programmed again.

To Set the Clock

CLOCK pad.
CLOCK
To Set the Timer
1. Press the
TIMER
TIMER
ON/OFF pad.
ON/OFF
2. Press the INCREASE or
DECREASE pad to set the
amount of time on timer.
To Cancel the Timer
Press the TIMER ON/OFF pad while the word
"TIMER" is displayed.
2. Press the
A
INCREASE or
DECREASE pad to
set the time of day.
3. Press the CLOCK pad to start.
The timer will start automatically
within a few seconds of releasing
the INCREASE or DECREASE pad.
The timer, as you are setting it,
will display hours and minutes.
"HR''will be in the display.
During the countdown, when the
timer reaches the last minute, the
display will change to seconds
only and a single beep will sound.