Connections - Panasonic KX-HNC200 Installation Manual

Setup
R Metal doors or screens
R Walls containing aluminum-sheet insulation
R Walls made of concrete or corrugated iron
R Double-pane glass windows
R Multiple walls
R When using each device on separate floors
or in different buildings
Note:
R The camera's LED indicator blinks in red if
it is out of range of the hub. In this case,
confirm all connections, including those of
the hub.
Usage area cautions
Using the camera in the following areas may
cause deformation, malfunction, or operational
failure.
R In direct sunlight
R Areas exposed to grease or steam, such as
kitchens
R Near fire or heating devices
R Near magnetic fields (such as near
microwaves and magnets)
R Areas subject to extreme temperature
changes, such as next to air conditioners
R Areas with reflective objects, such as glass,
that can interfere with detection of
temperature variation
R Areas where the temperature is affected by
strong illuminating objects (such as
fluorescent lights)
R Near devices that emit strong radio waves,
such as mobile phones

Connections

Insert the AC adaptor plug firmly into the
DC jack.
Connect the AC adaptor to the power
outlet.
For assistance, please visit http://shop.panasonic.com/support
10
HNC200_(en_en)_1005_ver.210.pdf
Note:
R Use only the supplied Panasonic AC
adaptor PNLV236.
1
Note about power connections
AC adaptor connection
R The AC adaptor must remain connected at
all times. (It is normal for the adaptor to feel
warm during use.)
R The AC adaptor should be connected to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight of
the adaptor may cause it to become
disconnected.
Power failure
R The camera will not work during a power
failure.
Placing the camera on a flat area
When you place the camera on a flat area,
you can prevent the camera from falling by
passing a string through the hole (page 7) in
the stand.
1
Pass a string (not supplied) through the
hole in the stand.
2
Tie the string and hook it to the bracket.
10
2
2015/10/06 13:23:03