Searching For A Station Or Zone From The List - Aiphone IS SERIES Operation Manual

Searching for a station or zone from the list

A
Searching for a station or zone by entering the
name [NAME SEARCH]
1
Select [NAME SEARCH] either in the standby mode
(→P. 25) or the SEARCH LIST (→P. 26).
2 Enter a name by using the dial keys.
e.g.)
When searching for "MASTER 004";
Press the dial keys as follows.
(4 times) (twice)
M A S T
The entered characters are displayed here.
All the station and/or zone names that include the entered
characters are displayed in the list.
The search is narrowed down whenever a character is
*
added.
NOTE:
You can also select a station from the list by using
you select [NAME SEARCH] in step 1.
(→P. 35)
(3 times) (8 times) (8 times) (4 times)
E R 0 0 4
after
To delete the just entered character:
Press .
To enter the same characters or characters on the
same dial key sequentially:
(e.g.: To enter "AB")
1. Enter "A". (Press the dial
2. Press .
3. Enter "B". (Press the dial
3 Press to select the target station or zone (so
that it is highlighted) from the list.
You can select up to 5 stations and/or zones if [ADD/
*
RMV] is displayed on the screen. (See below.)
4
Start calling (talking), monitoring or paging by
following the procedure for the corresponding
performance. (→P. 31-33)
To select two or more stations and/or zones from the
list: (When (Add/Remove) is displayed on the
screen)
LIST
1)
Press as
zone highlighted.
The station or zone is checked.
LIST
* Press as
2) Repeat step 1) to select more stations and/or zones.
You can select up to 5 stations and/or zones.
*
To select 5 stations and/or zones, after checking 4
stations and/or zones, select the 5th one so that it is
highlighted. (The 5th station or zone is not checked.)
key once.)
key twice.)
with the target station or
again to clear the check.
27