Table of Contents
Advertisement
•
Place metal studs at every corner of the false chimney brest; keep in mind the
thickness of the Promatec you use!
•
Build with Promatec around the steel building guide (fig.2-2)
•
Build the rest of the false chimney brest
4.6
Building the False Chimney Brest with a Frame
•
Make a framework of metal studs around building guides A and B (fig. 3-1); keep in
mind the thickness of the Promatec you use!
•
Place metal studs at every corner of the false chimney brest; keep in mind the
thickness of the Promatec you use!
•
Build with Promatec around the appliance against the building guides A and B (fig.3-1);
keep in mind that the appliance has to stick out of the walll and therefore nothing
must be build before the building guides!
•
Build the rest of the false chimney brest
4.7
Placing the Pebbles or placing the Log/Twig set
•
Place the pebbles (fig 1-3) or in case of a Log/Twig set spread the bottom of the
appliance over with the decorative black/yellow materials
•
Place the Twig set according to figure 1-1 or place the Log set according to fig.1-2
Never spread over more than one layer pebbles or embers!
Always check if the pilot light can be seen!
4.8
Placing the glass
Two suction pads are delivered with the appliance to make placing/removal easier.
Always clean the suction lifters before use
Place the suction lifters on the glass and bring the handles towards each other (see
figure 4-1)
Slide the top of the glass carefully in the glass opening and simultaneously slide the
glass upwards
Turn the bottom of the glass backwards
Slide the glass downwards till it stops
Place the strips at each side (see figures 4-3 and 4-4)
Place the seal cord around the glass opening and check for soundness
Place the decorative bottom strip
Place the decorative side strips over de magnets
(if applicable) Place the Frame
Remove stains from the glass (they can't be removed after the fire has been lit)
UK
IRL
>
>
>
> 12
Advertisement
Table of Contents
