Page 9
EN - Instruction on mounting and use Closely follow the instructions set out in this manual. All Accessible parts of the hood may became hot when used with responsibility, for any eventual inconveniences, damages or cooking appliance. fires caused by not complying with the instructions in this With regards to the technical and safety measures to be manual, is declined.
Electrical connection The hood is designed to be used either for exhausting or filter The mains power supply must correspond to the rating version. indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation.
replaced. Operation To reset the signal, keep T4 button pressed for 5”. Use the high suction speed in cases of concentrated kitchen The hood gives out a "BEEP" and LED 2 stops flashing. vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in In case of contemporaneous signalling of both filters, LEDs 1 operation during cooking and for another 15 minutes...
Maintenance Charcoal filter (filter version only) ATTENTION! Before performing any maintenance operation, Fig. 31 isolate the hood from the electrical supply by switching off at It absorbs unpleasant odours caused by cooking. the connector and removing the connector fuse. The activated charcoal filter can be one of these types: Or if the appliance has been connected through a plug and •...
Need help?
Do you have a question about the LIB0019252A and is the answer not in the manual?
Questions and answers