Operating Instructions - Health O Meter 597KL User Instructions

OPERATING INSTRUCTIONS

Set Up
1. Remove the protective film from the display window on the display head.
2. Ensure the scale base is on a stable, flat surface and that the sides of the base are clear of any
obstacles.
3. Utilizing the leveling bubble located at the top of the scale platform, level the scale by adjusting the
leveling feet at each corner of the underside of the base.
Powering the Scale
1. For AC operation – plug the adapter into the base of the scale and into the power source, or use the DC
IN plug on the back of the display module.
Note: The Auto Off function is only active when the scale is being used with batteries.
2. For battery operation, see Battery Installation below.
Battery Installation
1. Place the scale on its side. The battery holder is located in the center of the bottom of the base.
2. Slide the battery cover in the direction of the "open" arrow.
3. Place 6 C-cell batteries into the battery holder. Note the orientation that is shown and ensure the
batteries are placed in the proper direction. Do not use zinc-carbon batteries.
4. Replace the battery cover.
Note: When powering the scale via batteries, the AC adapter must be completely disconnected from
the scale.
Warning: If the scale will not be used for some time, remove all batteries to avoid a safety hazard. Disposal
of batteries should be done according to the national, regional or local regulations which apply to you for
disposal of batteries.
Battery compartment
(underside of scale platform)
13