752Kl Display Assembly Wall Mount Instructions - Health O Meter 597KL User Instructions

752KL DISPLAY ASSEMBLY WALL MOUNT INSTRUCTIONS

Required Parts and Tools (Not Included)
(1) Drill
(1) Phillips head Screwdriver
(2) #8 Anchoring screws (4.2 mm nominal OD)
(2) Mounting anchors, compatible with wall construction
Caution: When wall mounting the display assembly, ensure that the mounting location
is free of electrical lines, gas pipes, and other safety hazards. Ensure that the wall is of
construction that can support the display assembly.
Note: Remote head can be mounted to a wall up to 6 feet (1.83 m) from the base or it can be mounted on
the display bracket (included) for placement on a table up to 6 feet (1.83 m) from the base.
1. Use a Phillips head screwdriver to
remove the 2 screws securing the
bracket to the display module.
Retain the screws.Position the
display assembly bracket against the
wall, and mark the wall at the center
of each mounting hole.
2.
- If mounting to drywall or
plasterboard, use a 5mm (3/16")
drill bit to drill a lead hole into the
marked location.
- If mounting to wood, wood studs
or metal, use a 1.5mm (1/16")
drill bit to drill a lead hole into the
marked location.
5mm (3/16") drill bit
for mounting on
drywall or
plasterboard
11
1.5mm (1/16") drill bit
for mounting on wood,
wood studs or metal