iNels eLAN-RF-003 Installation Manual page 9


By pressing the button Save settings, you can save the current settings of your eLAN-RF-
003 including network settings.

The button IP Settings is to configure network settings that you can change any time based
on your network.
In case you set the static IP address, you have to find it by using the application (see detailed manual
for applications).
Note: If you change the IP address (setup a static IP address), to log into the eLAN-RF-003 you must use the new
IP address. If the new IP address that you entered is not in the same subnetwork, the connection will not work if
settings are not changed in the connected device (PC, iMM Client) to the same subnetwork.

The button Update firmware is used to update the firmware in your eLAN-RF-003.
When updating the eLAN-RF-003, proceed according to the following instructions:
1. Download the latest firmware version from the website
control-wireless-control/system-units/smart-rf-box-elan-rf-003-8488/
2. Click on the button Update firmware, select the downloaded file (the update file must always
include the extension *.bin), and click on it. After confirming by pressing OK, the update of your
firmware in your eLAN-RF-003 automatically starts.
Note: do not turn off device or use the Reset button when updating the firmware. the eLAN-RF-003 restarts after
updating. After the firmware update, all settings will remain preserved. This means that the set IP, login data,
visualization panel will remain the same as with the FW version prior to the update.
http://www.elkoep.com/products/inels-rf-
Manual / rev.7
eLAN-RF-003
9 of 16
Page