iNels eLAN-RF-003 Installation Manual page 10


The button RF mode is used to switch the mode of your eLAN-RF-003.
Repeater
The Repeater function is an independent function of eLAN-RF-003 and is used to increase range
between RF controllers (system elements) and RF elements.
Use: an eLAN-RF-003 device configured for a repeater can only be connected to the supply voltage,
and it will then function just the same as the RFRP-20. This means if it receives a command from the
RF controller or RF detector, it resends it to a designated RF element and vice-versa.

Oasis compatible
Enables the repeater function to serve unidirectionally communicating units (RF Key, RFWB,
RFIM, detectors, etc.).

RF Touch compatible
Enables the repeater function to serve bidirectionally communicating units (RF Touch, etc.).

List of addresses
Repeated address settings - write into the list of addresses those elements with which you
want the eLAN RF. If you set the eLANs to the Router mode, the same addresses must be set
for both eLANs...
After setting the function Repeater, eLAN restarts.
Manual / rev.7
eLAN-RF-003
10 of 16
Page