Fujitsu PRIMERGY BX630 S2 Service Supplement Manual page 12

Notes on Safety
V
ATTENTION!
Transport the device only in its original packaging or in packaging
which protects it from knocks and jolts.
Installation and operation
V
ATTENTION!
Read the notes on installation and operation in the Operating Manual
of the PRIMERGY BX600 S2 or BX600 S3 basic unit.
When installing the server blade in the basic unit, beware of the
energy hazard at the midplane conctacts. A short-circuit on these
contacts may damage the system.
Data cables must be adequately shielded to avoid interference.
For the LAN wiring, the requirements according to standards EN
50173 and EN 50174-1/2 apply. The minimum requirement is the use
of a protected LAN line of category 5 for 10/100 Mbps Ethernet,
and/or of category 5e for Gigabit Ethernet. The requirements of the
specification ISO/IEC 11801 must also be taken into account.
Route the cables in such a way that they do not form a potential
hazard (tripping) and cannot be damaged. When connecting the
device, refer to the relevant notes in the Operating Manual.
Do not connect or disconnect any data transmission cables during a
thunderstorm (lightning hazard).
Be careful to ensure that no objects (e.g. jewelry, paper clips etc.) or
liquids get inside the device (electric shock, short circuit).
In emergencies (e.g. damaged casing, elements, or cables,
penetration of liquids or foreign bodies), switch off the device immedi-
ately, unplug it from the grounded power outlet, and contact your
customer service centre.
Proper operation of the device (in accordance with IEC60950/EN
60950) is only ensured if the casing is completely assembled and the
rear covers for the installation openings are in place (electric shock,
cooling, fire protection, interference suppression).
12 Service Supplement
Important Notes
BX630 S2