Table of Contents
Advertisement
WMM Screen
WMM Enable
WMM - Power
Save Enable
Direct Link
Setup Enable
MAC Address
Timeout Value
Apply
Tear Down
5.6.
WPS
WPS (Wi-Fi Protected Setup) can simplify the process of connecting any device to the wireless
network by using the push button configuration (PBC) on the Wireless Access Point, or entering a
PIN code.
WMM is short for Wi-Fi Multimedia. It is a standard created to
define quality of service (QoS) in Wi-Fi networks. It is a precursor
to the upcoming IEEE802.11e WLAN QoS draft standard, which
is meant to improve audio, video and voice applications transmit-
ted over Wi-Fi. WMM adds prioritized capabilities to Wi-Fi
networks and optimizes their performance when multiple concur-
ring applications, each with different latency and throughput
requirements, compete for network resources. Click the check
box and then click "Apply" button to apply this function to the
system.
Click the check box, and select the desired type of power saving
mode.
Enable the check box and you may start to set MAC Address,
Timeout Value and check the DLS Status. Click "Apply" and this
setting will be applied to the system.
Enter the remote system which you want to connect with. When
you want to enable this function, you have to make sure that
your wireless network supports WMM function and then enter the
MAC address of the adapter which wants to connect with the
remote system.
The utility performs time-outs so that the program does not sit
idle waiting for input that may never come. Set a value to apply
to the system with WMM.
Click this button to save the changes you made.
Click this button will disconnect the selected Direct Link Setup.
34
Advertisement
Table of Contents
