Indication Of Programme Sequence; Options And Settings - Asko WM25 Service Manual

Service manual WM25

Indication of programme sequence

During the programme, the current programme sequence is indicated by a fixed light in the LEDs around the start/stop/
door open button (see the image).
Rinsing and spinning

Options and settings

Options
Settings
1400 1400
1000 1000
400 400 800 800
40 50
30 60
Cold 95
6
End
Final rinse
Increases the temperature and extends the time of the main wash
This option is only available on the American market.
White:
140°F / 170°F + approx 40 min
Colours: 105°F / 120°F + approximately 40 min
Permanent 105°F / 120°F + approximately 15 min
press:
Gives 2 – 4 extra rinses
This option cannot be selected with Wool/Hand wash, Rinse programme, Spin or Drain.
Delays the start of the machine by 5 hours
Activated by pressing the "Delayed start" button and then the start/stop button.
The number 5 in the display indicates that Time-delayed start has been activated. The num-
ber of hours to start is displayed with a countdown from 5 to 1.
Produces extra water in the main wash and rinses
Cannot be selected for wool/ hand wash, spinning and draining
It is possible to select spin speed between 400 and 1400 rpm, "No spin" and "No draining"
(option depending on machine type).
Spin at 400 – 800 rpm means a short spin.
For certain programmes, it is not possible to select a speed in excess of 800 rpm.
"No spin" means that the programme does not include a spin cycle and ends by draining.
"No draining" means that the programme does not include a spin cycle and ends with the
water from the final rinse still in the machine.
Possible to select temperatures between "Cold" and 95°C.
With "Cold" selected, the water in the machine is not heated.
Programme number 7 does not allow a temperature above 40°C to be selected.
Start
Heating up
Temperature reached