Digisol DG-CD1020HC User Manual page 24

DVR User Manual
2）Preset Point Calls
In Picture 3.10, click Page Switch button, enter PTZ control interface as shown in the Picture
3.12. In the input blank, write the preset points, then click Preset button, PTZ turn to the
corresponding preset point.
Value input blank
Picture 3.15 PTZ Control
2. Cruise between Points
Multiple preset points connected cruise lines, call cruise between points, the PTZ run around
on the line.
1）Cruise Between Points Settings
Cruise line is connected by multiple preset points, setting procedure is as follows:
Step1: In Picture 3.10, the Direction key will turn PTZ to designated location, click Settings
button to enter Picture 3.13.
Step 2: Click Cruise buttons, then write proper value into the Cruise Line and Preset Points
blank, then click Add Preset Points button, complete setting (also can add and delete cruise line
which has been set up)
Step 3: Repeat step1 and step2, until you set out all the preset designated cruise lines.
24