Table of Contents
Advertisement
ABOUT THE CERAMIC GLASS COOKTOP
The ceramic cooktop has radiant surface elements
located below the surface of the glass. The design of the
ceramic cooktop outlines the area of the surface element
underneath. Be sure to match the pan size with the
diameter of the element outline on the cooktop and only
flat-bottom cookware should be used.
The type and size of cookware, the number of surface
elements in use and their settings, are all factors that
will affect the amount of heat that will spread to areas
beyond the surface elements. The areas surrounding the
elements may become hot enough to cause burns.
ABOUT THE RADIANT SURFACE ELEMENTS
The element temperature rises gradually and evenly.
As the temperature rises, the element will glow red. To
maintain the selected setting the element will cycle on and
off. The heating element retains enough heat to provide a
uniform and consistent heat during the off cycle.
For efficient cooking, turn off the element several minutes
before cooking is complete. This will allow residual heat
to complete the cooking process.
note
Radiant elements have a limiter that allows the element
to cycle ON and OFF, even at the HI setting. This
helps to prevent damage to the ceramic smooth top.
Cycling at the HI setting is normal and can occur if the
cookware is too small for the radiant element or if the
cookware bottom is not flat.
Be sure to read detailed instructions for ceramic glass
cooktop cleaning in the general care & cleaning
section and Before You Call checklist section of this
Use and Care Guide.
note
Due to the high intensity of heat generated by the
surface elements, the glass surface will turn light green
when the element will be turned off. This phenomenon
is normal and the glass will come back to its original
white color after it has completely cooled down. (White
glass cooktops only).
BEFORE SETTING SURFACE CONTROLS
surFace cooking settings
Use the chart to determine the correct setting for the
type of food you are preparing.
Note: The size and type of cookware used will influence
the setting needed for best cooking results.
recommended setting for surface element
setting
HIGH (8-HI)
MEDIUM HIGH
(6-8)
MEDIUM (5)
MEDIUM LOW
(2 - 4)
LOW (LO-2)
caution
do not allow aluminum foil, or anY material that
can melt to make contact with the ceramic glass
cooktop. If these items melt on the cooktop they will
damage the ceramic cooktop.
caution
Radiant surface elements may appear to have
cooled after they have been turned OFF. The
continue to glow until the glass cooktop has cooled
down to a moderate level. the glass surface may
still be hot and burns may occur if the glass surface is
touched before the indicator light has turned OFF. The
indicator light may remain on even though the controls
are turned OFF.
Type of Cooking
Start most foods; bring water to a boil
and pan broiling.
Continue a rapid boil; frying, deep fat
frying.
Maintain a slow boil; thicken sauces
and gravies; steaming vegetables.
Keep foods cooking; poaching and
stewing.
Keep warm, melting and simmering.
indicator light will turn ON and will
9
Hide quick links:
Advertisement
Table of Contents
