Important Message - Toshiba Satellite C50-C User Manual

Blu-ray™ discs
Writing discs
You can use the DVD Super Multi drive to write data to either CD-R, CD-
RW, DVD-R, DVD-R DL, DVD-RW, DVD+R, DVD+R DL, DVD+RW or
DVD-RAM discs.
You can use the Blu-ray™ Writer drive to write data to either CD-R, CD-
RW, DVD-R, DVD-R DL, DVD-RW, DVD+R, DVD+R DL, DVD+RW, DVD-
RAM, BD-R, BD-R DL, BD-RE or BD-RE DL discs.
When writing information to media using an optical drive, you should
always ensure that you connect the AC adaptor to a live electrical outlet. It
is possible that, if data is written while powered by the battery pack, the
write process might sometimes fail due to low battery power. In these
instances, data loss might occur.

Important message

Before you write or rewrite to any of the media supported by the optical
disc drive, read and follow all of the setup and operating instructions in this
section. If you fail to do so, you might find that the optical disc drive might
not function properly, and you might fail to write or rewrite information
successfully. This might cause you to either lose data or incur other
damage to the drive or media.
Disclaimer
TOSHIBA does not assume responsibility for the following:
Given the technological limitations of current optical disc writing drives, you
might experience unexpected writing or rewriting errors due to disc quality
or problems with hardware devices. In view of this, it is good practice to
make two or more copies of important data, in case of any undesired
change or loss of the recorded contents.
User's Manual
BD-R and BD-R DL discs can be written only once. The recorded data
cannot be erased or changed.
BD-RE and BD-RE DL discs can be recorded more than once.
Damage to any disc that might be caused by writing or rewriting with
this product.
Any change or loss of the recorded contents of media that might be
caused by writing or rewriting with this product, or for any business
profit loss or business interruption that might be caused by the change
or loss of the recorded contents.
Damage that might be caused by using third party equipment or
software.
4-9