Troubleshooting - Stanley SDR1400 Manual

ENGLISH
(Original instructions)
Maintenance
♦ Before and after each use, check the product and
accessories (or attachments) for wear and damage. If
required, exchange them for new ones as described
in this instruction manual. Observe the technical
requirements.
Repair
This product does not contain any parts that can be
repaired by the consumer. Contact an authorised service
centre or a similarly qualified person to have it checked and
repaired.
Storage
♦ Switch the product off and disconnect it from the power
supply.
♦ Clean the product as described above.
♦ Store the product and its accessories in a dark, dry,
frostfree, well-ventilated place. Always store the
product in a place that is inaccessible to children. The
ideal storage temperature is between 10°C and 30°C.
♦ We recommend using the original package for storage
or covering the product with a suitable cloth or
enclosure to protect it against dust.
Transportation
♦ Switch the product off and disconnect it from the power
supply.
♦ Attach transportation guards, if applicable.
♦ Always carry the product by its handles (2).
♦ Protect the product from any heavy impact or strong
vibrations which may occur during transportation in
vehicles.
♦ Secure the product to prevent it from slipping or falling
over.

Troubleshooting

Suspected malfunctions are often due to causes that the
users can fix themselves. Therefore check the product
using this section. In most cases the problem can be solved
quickly.
Problem Possible
Cause
Product does not Not connected to
start power
supply
Power cord or
plug is
defective
Other electrical
defect to
the product
8
Product does not
reach full power
Unsatisfactory
result
Maintenance
Your tool has been designed to operate over a long period
of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
Warning! Before performing any maintenance, switch off
and unplug the tool.
♦ Regularly clean the ventilation slots in your tool using a
♦ Regularly clean the motor housing using a damp cloth.
Protecting the environment
Should you find one day that your Stanley product needs
replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
Solution
Connect to power
supply
Local regulations may provide for separate collection of
Check by a
electrical products from the household, at municipal waste
specialist
sites or by the retailer when you purchase a new product
electrician
Check by a
Remarks
specialist
♦ Stanley's policy is one of continuous improvement
electrician
Extension cord
not suitable for
operation with
this product
Power source
(e.g.
generator) has
too low
voltage
Air vents are
blocked
Stirrer is worn
Stirrer not
suitable for
material to be
mixed
soft brush or dry cloth.
Do not use any abrasive or solvent-based cleaner.
Separate collection. This product must not be
disposed of with normal household waste.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials.
to our products and as such, we reserve the right to
modify product specifications without prior notice.
Use a proper
extension cord
Connect to
another
power source
Clean the air
vents
Replace with new
one
Use proper stirrer