Turning On Power To The Operator - Allstar AUD-S Installation And Owner's Manual

12
3/SINGLE BUTTON STATION / INTERLOCK FIELD WIRING
MOTOR
R84
R2
CONTROL
R3
U5
C25
BOARD
PB1 PB2 PB3
D12
OPEN CLOSE STOP
Single 3 Button Station
MOTOR
CONTROL
BOARD
TURNING ON THE POWER TO THE OPERATOR
NOTE: It is now necessary to turn on the power in order to change the Operating Mode (if
applicable), program any changes desired to the operator's other settings, check for proper
performance of all the operator's features to include the brake (if applicable) and clutch
(adjusting settings if necessary); and to set and finalize any adjustments to the limit settings.
Before doing so, ensure that all mounting hardware are installed and properly tightened, that all
electrical connections are per local code requirements, and that proper wiring practices have been
followed. Also, double-check that all ropes have been removed from the door and that the
doorway is clear.
Figure 17
R93
D1
R4
R8
C21
R24
TB1
EXTERNAL INTERLOCK
D3
R65
C10
MOTOR
D2
CONTROL
BOARD
R38
R87
R94
R95
R2
R3
C25
PB1 PB2 PB3
OPEN CLOSE STOP
Multiple 3 Button Station
U5
Single Button and External Interlock Wiring
Note: When adding an External Interlock
remove the factory installed jumper from
the connection terminals.
R5
R57
R25
RADIO
C24
24V
D8
COM
RM3
RM2
RM1
VCC
P7
R54
R55
R56
D12
Figure 18
Figure 19