Storing Your Washer; Cleaning The Debris Fi Lter - Samsung WD1142XVM User Manual

STORING YOUR WASHER

Washers can be damaged if water is not removed from hoses and internal components before storage.
Prepare your Washer for storage as follows:
• Select the Quick Wash cycle and add bleach to the automatic dispenser. Run your Washer through the
cycle without a load.
• Turn the water faucets off and disconnect the inlet hoses.
• Unplug your Washer from the electrical outlet and leave your Washer door open to let air circulate inside
the tumbler.
• If your Washer has been stored in below–freezing temperatures, allow time for any leftover water in your
Washer to thaw out before use.
CLEANING THE DEBRIS FILTER
We recommend cleaning the debris fi lter when water does not drain well or the "ND" error message is
displayed.
1. Unplug the power cord of the washing machine from the main
socket.
Gently press the top area of the fi lter cover to open.
2. Unscrew the drain cap by turning it
counterclockwise.
3. Hold the cap on the end of the drain tube and
slowly pull it out about 6 inches (15 cm) and
drain off all the water.
4. Remove the debris fi lter cap.
5. Wash any dirt or other material from the
debris fi lter. Make sure the drain pump
propeller behind the debris fi lter is not
blocked.
6. Replace the debris fi lter cap.
7. Replace the fi lter cover.
For models with the safety fi lter cap
•
•
YUKON-03073P-04_EN.indd 35 YUKON-03073P-04_EN.indd 35
To open, push in, and then turn the safety fi lter cap
counterclockwise. The spring in the cap will make opening the cap
easy.
To close, turn the safety fi lter cap clockwise. As you turn the cap,
the spring will make a rattling sound. The rattling sound is normal.
English - 35
Step 1 Step 2
4/7/2016 11:31:31 PM 4/7/2016 11:31:31 PM