Network Setup - Samsung HT-J5500K User Manual

✎
To delete all Preset FM stations at once, press the
TITLE MENU
button for about 5 seconds in FM
Manual mode until DEFAULT PRESET appears
on the display.
Recording FM Radio
You can record your favorite radio broadcast on a
USB storage device.
1.
Insert a USB device into the USB jack on the
front of the product.
2. FUNCTION
Press the
TUNING
then press the
select the station you want to record.
3. RED (A)
Press the button to start recording. The
recording process begins.
~ The recorded time is displayed on the left and
the recording time still available, based on
the amount of free space in the USB storage
device, is displayed on the right.
4. EXIT
Press the button to finish your recording.
The recording is stopped and saved as an .mp3
file at the same time. To play the recorded file,
refer to "Playing Files on a USB Device".
The recorded file is saved in the Tuner folder which
✎
is created automatically.
✎
Only the (OPEN/CLOSE),
MUTE, and VOLUME +/-, buttons are operable
while FM radio is being recorded.
5V 0.5A
✎
If you don't press any buttons while recording, the
5V 0.5A
screen saver will be enabled.
✎
Sound effects, such as DSP, EQ, etc., are not
recorded during FM radio recording.
✎
The radio is recorded at a set, default volume
even if you change the volume or press the
button during the recording process.
✎
If you remove the USB device or Power Cable
during the recording process, the portion of the
file which has already been recorded may not play
back.
✎
Recording will not start if the remaining free space
in the USB storage device is less than 2MB.
✎
If the USB device is removed or has insufficient
space (under 2MB), the appropriate message is
displayed and the recording stops.
button to select FM, and
UP, DOWN
button to
(POWER), EXIT,
MUTE
21

Network Setup

When you connect this product to a network, you
can use network based applications and functions
such as BD-LIVE and upgrade the product's software
through the network connection.
Configuring Your Network Connection
To begin configuring your network connection, follow
these steps:
1. In the Home screen, select Settings, and then
press the v button.
2. Select Network, and then press the v button.
3. Select Network Settings, and then press the
v button.
4.
Go to the instructions for Wired networks starting
below or the instructions for Wireless networks.
(See page 22)
Wired Network
Wired – Automatic
Ğ Ğ
After following Steps 1 to 3 above:
1. In the Network Settings screen, change
Network Type to Wired. Then, select Connect
and press the v button. The product detects
the wired connection, verifies the network
connection, and then connects to the network.
2. When it is done, highlight OK, and then press
v button.
Wired - Manual
Ğ Ğ
If you have a static IP address or the automatic
procedure does not work, you'll need to set the
Network Settings values manually.
After following Steps 1 to 3 above:
1. In the Network Settings screen, change
Network Type to Wired. Then, select Connect
and press the v button.
The product searches for a network, and then
displays the connection failed message.
✎
If it is possible to connect the home theater to
your network wirelessly, select Change Network
at this point, change the Network Type to
Wireless, and then go to the instructions for
wireless networks. (See page 22)
- English