Network Setup - Samsung HT-H5200 User Manual

Software Upgrade
For more information about this function see page
20.
Contact Samsung
Provides contact information for assistance with
your product.
Terms of Service Agreement
View the general disclaimer regarding third party
contents and services.
Reset
Reverts all settings to their defaults except for the
network. Requires that you enter your security PIN.
The default security PIN is 0000.

Network Setup

When you connect this product to a network, you
can use network based applications and functions
such as BD-LIVE and upgrade the product's software
through the network connection.
Configuring Your Network Connection
To begin configuring your network connection, follow
these steps:
1. In the Home screen, select Settings, and then
press the E button.
Select Network, and then press the E button.
2.
3. Select Network Settings, and then press the
E button.
4. Go to the instructions for Wired networks
starting below or the instructions for Wireless
networks. (See page 18)
Wired Network
K
Wired – Automatic
After following Steps 1 to 3 above:
1. In the Network Settings screen, change
Network Type to Wired. Then, select Connect
and press the E button. The product detects
the wired connection, verifies the network
connection, and then connects to the network.
HT-H5200_HS5200-ENG_0402.indd 17 HT-H5200_HS5200-ENG_0402.indd 17
Support
17
2. When it is done, highlight OK, and then press
E button.
K
Wired - Manual
If you have a static IP address or the automatic
procedure does not work, you'll need to set the
Network Settings values manually.
After following Steps 1 to 3 above:
1. In the Network Settings screen, change
Network Type to Wired. Then, select Connect
and press the E button.
The product searches for a network, and then
displays the connection failed message.
✎
If it is possible to connect the home cinema to
your network wirelessly, select Change Network
at this point, change the Network Type to
Wireless, and then go to the instructions for
wireless networks. (See page 18)
Network Settings
Wired network connection failed.
IP auto setting failed. Try the following to set up the IP automatically, or set up the IP manually
by selecting IP Settings.
- Ensure that the DHCP server is enabled on the wireless network, then unplug and plug the wireless
network in again.
- Contact your internet service provider for more info.
Change Network IP Settings
a Previous
2. Use the ◄► buttons to select IP Settings,
and then press the E button. The IP Settings
screen appears.
3. Select the IP setting field, and then set it to
Enter manually.
4. Select a parameter to enter (IP Address, for
example), and then press E . Use the number
keypad on your remote control to enter the
numbers for the parameter. You can also enter
numbers using the ▲▼ buttons. Use the ◄►
buttons on the remote control to move from
entry field to entry field within a parameter. When
done with one parameter, press the E button.
5. Press the ▲ or ▼ button to move to another
parameter, and then enter the numbers for that
parameter following the instructions in Step 4.
- English
MAC Address XX:XX:XX:XX:XX:XX
IP Address 0. 0. 0. 0
Subnet Mask 0. 0. 0. 0
Gateway 0. 0. 0. 0
DNS Server 0. 0. 0. 0
Retry Close
d Skip < Move " Select
2014-04-02 2014-04-02 3:12:06 3:12:06