Makita 2012NB Instruction Manual page 5

003712
CAUTION:
Always lower the main frame when aligning the
•
indicator plate with the graduation indicating the
desired finished dimension. If you raise the main
frame into the
additional play in the screw may result. This may
cause an undesired finished dimension.
Always place the workpiece flat on the table top
•
when predetermining the depth of cut. Otherwise,
the predetermined depth of cut will differ from
actual depth of cut.
Depth adjusting gauge
1
3
003713
Use the depth adjusting gauge when you need to
predetermine the depth of cut more accurately. To do so,
proceed as follows.
1. First, plane the workpiece at the predetermined
depth of cut. Measure the thickness of the planed
piece to know how much more stock you need to
remove.
2. Turn the depth adjusting gauge on the crank
handle until the 0 graduation is aligned with the
groove on the tool.
3. Now turn the crank handle counterclockwise until
the graduation for the desired depth of cut is
aligned with the groove on the tool.
4. When you need to remove more than the amount
specified in the table mentioned in the "Adjusting
depth of cut" section, set the depth of cut
shallower than the amount and make two or more
passes.
1. Depth gauge
1
desired finished dimension,
1. Crank handle
2. Groove
3. Depth adjusting
gauge
2
Stopper
003714
Use the stopper when you need to plane many
workpieces to the same thickness. To do so, proceed as
follows.
1. Turn the crank handle until the indicator plate
points to the scale graduation indicating the
desired finished dimension.
2. Depress the stopper button and lower the stopper
until it just contacts the table top.
3. If you need fine adjustment of the stopper, turn the
stopper knob.
CAUTION:
When the stopper is not in use, always raise it to
•
the topmost position. Never force the crank handle
when the stopper is in contact with the table top.
This may cause tool damage.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Replacing planer blades
CAUTION:
Handle the blades very carefully when removing or
•
installing the blades to prevent cuts or injury from
the blades and to prevent damage to the blades.
They are razor-sharp.
Clean out all chips, dust, pitch or foreign matter
•
adhering to the drum or blades before installing the
blades.
Use blades of the same dimensions and weight , or
•
drum oscillation/vibration will result, causing poor
cutting action and eventually, tool breakdown.
Replace both blades at the same time.
•
The disposable-type blade has a cutting edge on
•
both sides. When one cutting edge becomes dull,
you can use the other cutting edge. Always remove
resin and dirt sticking to the reverse side of the
blade before using the other cutting edge. This
blade must not be re-sharpened. When both cutting
edges become dull, the blade should be carefully
5
1. Stopper
2. Stopper button
3. Stopper knob
4. Table top
1
2
3
4