Belling XOU250 Installation And User Instructions Manual page 5

WARNING: THIS APPLIANCE MUST BE EARTHED!
This oven should be installed by a competent electrician
in accordance with the current edition of IEE Regulations.
This appliance must be earthed and connected to a
230volt, 50 Hz, single phase supply through a suitable
oven control unit with a fuse rating of 20 amps. The
control unit should incorporate a double pole switch
having a contact separation of at least 3 mm in all poles
and should be located adjacent to the oven to allow
easy access in case of an emergency.
We recommend that you use a rubber cable (type
H0 5RR-F) to connect the oven to the control unit or
other protective cables with similar type characteristics.
The minimum cable size is 3 x 1.5 mm
terminal block is located on the rear of the oven and
should be connected as shown in the diagram. Access
to the terminals is made possible by removing the screw
immediately above the black plastic terminal cover, and
hinging the cover downwards.
The power cable must be laid so that no parts of it ever
reach an over temperature of 75K.
Live Terminal
Neutral Terminal
Earth Terminal
Mains Cable
Cable Clamp
G87
ELECTRICAL INSTALLATION
2
. The oven mains
Terminal
Cover
Access Screw
5