Table of Contents
Advertisement
Impact
This icon will be displayed if an impact to the vehicle is detected while the system is armed. The remote will beep
rapidly while displaying this icon if the impact is hard; this means that the alarm was triggered. If it beeps slowly while
displaying this icon, that means that the impact was soft and that the alarm simply gave four warning chirps.
Door
This icon will be displayed if the door is opened while the system is armed. The remote will beep rapidly while
displaying this icon. This means that the alarm was triggered. If this icon appears while trying to remote-start the
vehicle, it means that the vehicle will not start because the door is open.
Trunk
This icon will be displayed if the trunk is opened while the system is armed. The remote will beep rapidly while
displaying this icon. This means that the alarm was triggered. If this icon appears while trying to remote-start the
vehicle, it means that the vehicle will not start because the trunk is open.
Car Call
This icon will be displayed while someone is attempting to contact you using the RPS sensor. To trigger the RPS
sensor, you must knock on the windshield where the sensor is located. Something that creates a higher pitch, like a
key, is better suited to trigger the RPS.
Advanced Icons –
Passive Mode
This icon will be displayed if Passive mode is currently active. Passive mode will automatically arm the system 30
seconds after the last door is closed or 30 seconds after the system was disarmed if no door was opened. This mode
is ignored while the ignition is on with the key.
Drive Lock
This icon will be displayed if Drive Lock mode is currently active. Drive Lock mode will lock the doors automatically if
the ignition is on and the brake is pressed or if the ignition is on and the engine exceeds the idle RPM multiplied by 2,
depending on the options set by the installer. The doors will be unlocked when the ignition is turned off. In a manual
transmission vehicle the doors will unlock when the emergency brake is set.
Turbo Mode
This icon will be displayed if Turbo mode is currently active. While Turbo mode is active, the vehicle will remain
running for a preset time after the emergency brake has been set and the key has been removed from the ignition.
nd
2
Car Mode
This will be displayed while you are in 2
same system installed in it. The remote needs to be coded to the other vehicle in 2
work.
Vibration
This icon will be displayed if the remote is set to vibrate only. While the remote is set to vibrate only the remote
will not beep, even if the alarm is triggered. The remote will still vibrate in this mode.
Alarm Clock
This icon will be displayed if the Alarm Clock function is turned on. When the clock reaches the preset time, the
remote will beep and flash the alarm clock icon. Press the Key/Start button for a half sec. to silence the remote.
Shock Sensor Bypassed
This icon will be displayed when the shock sensor is bypassed by holding the Lock and Unlock buttons <insert
icon> for 2.5 sec. Impact to the vehicle will not be detected at this time. This icon is always displayed on starter
only systems because there is no shock sensor.
Aux Mode
(Alarm or alarm/starter systems only.)
This icon will be displayed while you are in Aux mode. During this time, you can activate auxiliary outputs 1 or 2
by pressing Function button then Trunk or Function button then Key/Start
activate various systems or functions in a vehicle.
Voltage
This icon will be displayed while the remote is reporting the voltage of the vehicle or remote battery.
Temperature
This icon will be displayed while the remote is reporting the temperature of the vehicle.
nd
nd
Car mode. 2
Car mode allows you to control another vehicle with the
10
nd
Car mode for this feature to
. Aux outputs can be used to
Hide quick links:
Advertisement
Table of Contents
