Technical Descriptions; Us-Dect Description - Panasonic KX-TG4763B Service Manual

4 Technical Descriptions

4.1.

US-DECT Description

The frequency range of 1.92 GHz-1.93 GHz is used. Transmitting and receiving carrier between base unit and handset is same
frequency. Refer to Frequency Table (P.66).
4.1.1. TDD Frame Format
RX1
4.1.2. TDMA system
This system is the cycles of 10 ms, and has 6 duplex paths, but maximum duplex communication path is 5 because of dummy
bearer use.
In 1 slot 417 µs, the 10 ms of voice data is transmitted.
• 2 - Handsets Link
Traffic Bearer
A link is established between base unit and handset.
The state where duplex communication is performed.
Handset doesn't make up duplex in no free RF channels because of interference. (*1)
Dummy Bearer
Base unit sends Dummy-data to the all stand-by state handsets.
Handsets receive that data for synchronization and monitoring request from the base unit.
Base unit doesn't send Dummy bearer in no free RF channels because of interference. (*1)
Note:
(*1) It is a feature under FCC 15 regulation and for interference avoidance.
In the case of checking RF parts, it is better in least interference condition.
Downloaded from www.Manualslib.com
5 ms
Up Link ( Handset - > Base Unit )
RX2 RX3 RX4 RX5
DATA rate : 1.152 Mbps
RX1 RX2 RX3 RX4 RX5 RX6 TX1 TX2 TX3 TX4 TX5 TX6
Base unit
Handset 1
(Stand by)
Handset 2
(Link)
Handset 3
(Link)
manuals search engine
Down Link ( Base Unit - > Handset )
RX6 TX1 TX2
417 µs (available) 417 µs (blind)
Traffic Bearer Dummy bearer
TX
TX
7
KX-TG4763B/KX-TGA470B/KX-TGA405B
5 ms
TX3 TX4 TX5
RX
RX
TX6