Other Problems - Miele T 4859 Ci SUPERTRONIC Operating Instructions Manual

Problem solving guide

Other problems

Problem
The drying
process goes on
too long or even
switches off.
50
Possible cause
The request to clean the
airways may appear in the
display.
Ventilation to and from the
dryer may be insufficient,
e.g. because it is installed
in a room which is too
small. This can cause the
temperature in the room to
rise sharply.
The vents below the door
are blocked.
The fluff filters are clogged
up.
The fluff filters were wet
when replaced.
Detergent residues, hair
and fine fibres can block
the condenser unit.
The laundry has not been
spun sufficiently.
The tumble dryer has been
overloaded.
Metallic components, e.g.
zips have prevented the
dryer from registering the
correct moisture level in the
laundry.
Remedy
Please check all the possible
causes and switch the dryer off
and then back on again.
– Open a door or window while
the dryer is in operation for
increased air flow.
– Remove any objects that are
blocking the vents.
See "Cleaning and care".
– Remove any fluff.
– The fluff filters must be
completely dry.
See "Cleaning and care".
– The condenser unit must be
checked and cleaned if
necessary.
– Make sure that your laundry is
thoroughly spun at the
appropriate spin speed in the
washing machine.
– Do not exceed the maximum
load for the programme
selected.
– Open zips next time.
– If the problem occurs again,
dry garments with long zips
using the Warm air
programme (timed drying).