Sony HDR-UX10 Operating Manual page 134

Precautions and maintenance (Continued)
®
Remove dust from the eyecup block
with a camera blower, etc.
@
Press the viewfinder back onto the body
of the camcorder.
®
Remove dust from the inside area where
the eyecup block was attached with a
camera blower, etc.
®
Attach the eyecup block to the
viewfinder, pushing it straight on until it
clicks.
On charging the pre-installed
rechargeable baUery
Your camcorder has a pre-installed
rechargeable battery to retain the date, time,
and other settings even when the POWER
switch is set to OFF (CHG). The pre-
installed rechargeable battery is always
charged while your camcorder is connected
to the wall outlet (wall socket) via the AC
Adaptor or while the battery pack is
attached. The rechargeable battery will be
fully discharged in about 3 months if you
do not use your camcorder at all. Use your
camcorder after charging the pre-installed
rechargeable battery.
However, even if the pre-installed
rechargeable battery is not charged, the
camcorder operation will not be affected as
long as you are not recording the date.
• Procedures
Connect your camcorder to a wall outlet
(wall socket) using the supplied AC
Adaptor, and leave it with the POWER
switch set to OFF (CHG) for more than 24
hours.
134
" Notes
• The eyecup block is a precision part. Do not
disassemble it further.
• Do not touch the lens of the eyecup block.