Table of Contents
Advertisement
Disassembly Procedures
!
WARNING
Pressure Switch
1. Loosen control hood assembly, see "Control Hood
Assembly" procedure steps 1 and 2.
2. Disconnect wires and plastic hose from pressure
switch.
3. Remove screws securing pressure switch to
control hood mounting plate.
4. Reverse procedure to reassemble.
NOTE: See appropriate wiring diagram when
rewiring components.
NOTE: Before connecting hose to pressure switch,
blow air through pressure hose to remove
any condensation that may have
accumulated in the hose.
Graphic Panel
1. Remove all knobs from switches.
2. Loosen control hood assembly, see "Control Hood
Assembly" procedure steps 1 and 2.
3. Disconnect wires from components and carefully
remove components from control hood assembly,
see component removal procedure listed earlier.
4. Remove screws securing top cover to control
mounting plate and remove top cover.
5. Remove screws securing end panels (each side)
and remove end panels.
6. Remove grounding clip secured to metal tab on
graphic panel.
7. Bend tabs on graphic panel (located inside of
control hood) straight out towards the rear.
8. Remove graphic panel from front of control
mounting plate.
9. Reverse procedure to reassemble.
NOTE: See appropriate wiring diagram when
rewiring components.
To avoid risk of electrical shock, personal injury, or
death, disconnect power to unit before servicing.
Loading Door
1. Open loading door.
2. Remove screws securing left hinge to door and
remove hinge.
Loading
door
Hinge
attaching
screws
Hinge
(left side)
3. Raise loading door to a vertical position,
disengage loading door from loading door clip by
swing left side of door toward front of washer.
4. Rotate loading door so door is upside down.
22
Hinge
attaching
screws
Hinge
(right side)
Loading
door
Hide quick links:
Advertisement
Table of Contents
