Temperature And Speed Switch - GE WDSS4120 Technical Service Manual

Disassembly Procedures
!
Before attaching wire harness terminal blocks to timer,
verify all male terminals on timer are straight and are
capable of accepting terminals from wire harness
terminal blocks.
NOTE: When installing timer, verify timer is installed
correctly and is securely mounted to control
mounting plate.
!
CAUTION
To avoid risk of timer damage, do not allow timer
to be struck on the corners, edges of frame, or on
timer shaft.
End panel
(left side)
Screw
Control
knob
Rocker
switch
(some models)
Timer
knob
Graphic
panel
WARNING
Top
cover
Screw
Timer
knob
skirt
Screw
Hold-down
Typical Control Panel Assembly
To avoid risk of electrical shock, personal injury, or
death, disconnect power to unit before servicing.

Temperature and Speed Switch

1. Loosen control hood assembly, see "Control Hood
Assembly" procedure steps 1 and 2.
2. Slide a soft cloth under the knob, wrapping the
entire knob and pull gently away from the control
panel.
3. Disconnect wires from switch terminals.
4. From the front, press inward on black plastic
tabs next to the switch shaft and rotate switch to
release switch from control hood mounting plate.
5. Reverse procedure to reassemble.
NOTE: See appropriate wiring diagram when rewiring
components.
Screws
Temperature
switch
Ground
clip
Control
mounting
plate
Control hood
rear panel
clip
21
Pressure
switch
Screw
Speed
switch
Timer
Screw
Screw
End panel
(right side)
Screw