Table of Contents
Advertisement
Component Testing Information
To avoid risk of electrical shock, personal injury, or death, disconnect power to washer before servicing, unless
testing requires it.
Illustration
Motor
Drain pump
Transmission
assembly
Drive belt
Power Cord
!
Component
Type of motor:
Two speed
Verify drain pump is not clogged or
damaged.
Type of transmission:
640 rpm
Type of drive belt:
640 rpm
Refer to "Parts Manual" for proper
pulley size.
Measure resistance of wires.
WARNING
Test Procedure
9
Results
See following section "Internal Motor
Diagram and Schematic" for correct
wiring contacts.
Remove clog and verify proper operation.
Replace drain pump if damaged.
If transmission locks-up, replace.
Refer to "Parts Manual", to verify which
drive belt and pulley size is required.
Continuity should be indicated on each
wire.
Verify polarity and grounding.
Hide quick links:
Advertisement
Table of Contents
