Installation Instructions - Skytech 3301P2 Installation And Operation Manual

Installation and operation instructions manual (9 pages)

Table of Contents

RECEIVER

Install the (4) AA-size batteries supplied with the unit. It is recommended that ALKALINE batteries always be used for this

product. Be sure the batteries are installed with the (+) and (-) ends facing the correct direction.

The remote receiver has a 3-position slide switch for selecting the mode of operation ON/REMOTE/OFF.

ON: will manually turn ON the appliance.

REMOTE: will allow use of handheld transmitter. If the system

does not respond to the transmitter on initial use, check the

battery positions in the remote. If that does not work, see the

LEARNING TRANSMITTER TO RECEIVER section.

OFF: will disable the remote receiver.

NOTE: It is suggested that the slide switch be placed in the

OFF position if you will be away from your home for

vacation or an extended period of time.

This remote control system must be installed exactly as outlined in these instructions. Read all instructions completely

before attempting installation. Follow instructions carefully during installation. Any modifications of this remote control

or any of its components will void the warranty and may pose a fire hazard.

Do not connect any gas valve or electronic module directly to 110-120VAC power. Consult gas appliance

manufacturer's instructions and wiring schematics for proper placement of all wires. All electronic modules are to be

The following wiring diagrams are for illustration purpose only. Follow instructions from manufacturer of gas valve and/

or electronic module for correct wiring procedures. Improper installation of electric components can cause damage to

The remote receiver can be Wall Mounted into a standard plastic switch box or (Hearth Mounted) placed on or near the

fireplace hearth. Determine where you will install the receiver before proceeding. Preferably, the remote receiver should

be wall-mounted in a plastic switch box, as this will protect its electronic components from both the heat produced by the

gas appliance and potential damage or abuse that can occur if it is left exposed on the hearth. PROTECTION FROM

EXTREME HEAT IS VERY IMPORTANT. Like any piece of electronic equipment the receiver should be kept away from

temperatures exceeding 130°F inside the receiver case. Battery life is also significantly shortened if batteries are exposed

to high temperatures.

When installing the receiver into a switch box ensure the receiver switch is in the OFF position before installation. The

receiver is supplied with 18-inches of wire. If additional wire is required it is recommended that 18 gauge stranded or solid

wires (not included) be used to make connections between the terminal wiring block on the millivolt gas valve or electronic

module and the wire terminals on the remote receiver. For the best results, use 18 gauge stranded or solid wire, splice

into the black wires of the receiver or remove the black wires and install wires directly to the receiver. Be sure no splices

measure longer than 20-feet and allow ample wire to remove the receiver for annual battery replacement.

Skytech: 3301P2

WARNING

wired to manufacturer's specifications.

electronic module, gas valve and remote receiver.