Table of Contents
Advertisement
Tilt Steering Pedal
To tilt the steering wheel towards you, press the foot
pedal (Figure 23) down, and pull the steering tower
toward you to the most comfortable position and then
release the pedal.
Throttle Control
Move the throttle control (Figure 24) forward to increase
the engine speed and rearward to decrease speed.
6
5
4
3
2
1
Figure 24
1. Throttle control
2. Enable/disable switch
3. Glow plug indicator light
4. Engine coolant
temperature warning
light
5. Diagnostic light
Key Switch
The key switch (Figure 24) has three positions: Off,
On/Preheat, and Start.
Engine Coolant Temperature Warning
Light
This light (Figure 24) illuminates and the cutterheads
shut down when the engine coolant reaches a high
temperature. If the engine temperature continues to rise,
the engine will shut down.
7
8
9
10
G003956
6. Engine coolant
temperature gauge
7. Engine oil pressure
warning light
8. Charge indicator
9. Key switch
10. Lower mow/raise control
lever
Engine Coolant Temperature Gauge
During normal operating conditions the gauge
(Figure 24) should be in the green range. Check the
cooling system if the gauge goes to the yellow or red
range.
Diagnostic Light
It will illuminate should a system fault be recognized.
Lower Mow/Raise Control Lever
This lever (Figure 24) raises and lowers the cutting units
and also starts and stops the cutterheads when the
cutterheads are enabled in the mow mode.
Glow Plug Indicator Light
This light (Figure 24) illuminates when the glow plugs
are preheating.
Engine Oil Pressure Warning Light
This light (Figure 24) indicates dangerously low engine
oil pressure.
Charge Indicator
The charge indicator (Figure 24) illuminates when the
system charging circuit malfunctions.
Enable/Disable Switch
Use the enable/disable switch (Figure 24) in conjunction
with the lower mow/raise control lever to operate the
cutterheads. The cutterheads cannot be lowered when
the mow/transport lever is in the transport position.
Backlap Levers
Use the backlap levers in conjunction with the lower
mow/raise control lever for backlapping the reels
(Figure 25).
Reel Speed Controls
The reel speed controls control the speed of the front
and rear cutting units (Figure 25). The reel speed
increases as the knobs are turned counter clockwise.
21
Advertisement
Table of Contents
