Filling The Fuel Tank; Checking The Engine-Oil Level; Adjusting The Handle Height - Toro Recycler 20334 Operator's Manual

Filling the Fuel Tank

•
For best results, use only clean, fresh, unleaded gasoline
with an octane rating of 87 or higher ((R+M)/2 rating
method).
•
Oxygenated fuel with up to 10% ethanol or 15% MTBE
by volume is acceptable.
•
Do not use ethanol blends of gasoline, such as E15
or E85, with more than 10% ethanol by volume.
Performance problems and/or engine damage may result,
which may not be covered under warranty.
•
Do not use gasoline containing methanol.
•
Do not store fuel either in the fuel tank or in fuel
containers over the winter unless fuel stabilizer has been
added to the fuel.
•
Do not add oil to gasoline.
Important: To reduce starting problems, add fuel
stabilizer to the fuel all season, mixing it with gasoline
less than 30 days old.
Figure 13

Checking the Engine-Oil Level

Service Interval: Before each use or daily
1. Move the machine to a level surface.
2. Remove the dipstick, wipe it clean, and fully install the
dipstick (Figure 14).
1. Dipstick
2. Add mark
3. Remove the dipstick and check the oil level
If the oil level is below the Add mark on the dipstick,
slowly pour oil into the oil fill tube to raise the oil level
to the Full mark on the dipstick. Do not overfill.
4. Install the dipstick securely.

Adjusting the Handle Height

You can raise or lower the handle in 1 of 2 positions that is
more comfortable for you
1. Loosen both handle knobs until you can push the
square edges of the carriage bolts out of the square
holes in the handle brackets.
2. Push the knobs until they are loose.
3. Move the handle to the upper or lower height position.
4. Pull the knobs until the square edges of each carriage
bolt fits into its related square hole.
5. Tighten the handle knobs as tight as you can.
9
Figure 14
3. Full mark
(Figure
(Figure 15).
Figure 15
14).